First installation

  1. Take your Homebase and look at the ports on the back side.

  2. Plug the Homebase into electricity via the middle port.

  3. Connect the ethernet cable to the right port. The internet must have a support of DHCP. Make sure that the LEDs are flashing.

  4. Choose one of the 30 channels by listing with the front buttons below the display. Then switch the Homebase into pairing mode by long press of the both buttons together. In pairing mode, the display will turn into violet colour and will remain in this mode for 1 minute.

  5. Connect Plugsense into the wall socket and push the button for 5 seconds. Plugsense should pair with the Homebase.

  6. Connect the measured appliance to the Plugsense. By the pressing of the button, you can turn appliance on and off.

  7. Go to http://energomonitor.com/setup and create your account. You can find required serial number of the device on the bottom side of the Homebase.


Usage

  • The default state of the Plugsense is "on" state. So, in the case of an electrical outage, the Plugsense will always skip to "on" mode when electric starts to work again. Be aware of this behaviour.


The plug used to work, but now the application shows just “This device seemsto be disconnected”

  • Log out from the application and then log in again.