Instructions for Thermosense Indoor

  1. Choose one of the empty channels on your Homebase and switch the Homebase into
  2. pairing mode. The Homebase remains in this mode for 1 minute.
  3. Take the Thermosense sensor and push the embedded button at the front for 2 seconds. LED on the side of the cover will flash lengthy first and then will start blinking fast.
  4. The thermometer is now searching for the Homebase. Devices will pair with each other. On the display of the Homebase, there will occur information about current temperature in tenths of °C (e.g. '245').
  5. Now, wait. The pairing sequence will end after 1 minute, and the Homebase will show actual temperature in final format (e.g. '24.5°C'). Homebase and Thermosense sensor will come into the general operating state. If the pairing process has failed, repeat it again from the point number 1.
  6. Open the Energomonitor app in your browser and configure the new sensor.


Instructions for Thermosense Outdoor

  1. Choose one of the empty channels on your Homebase and switch the Homebase into pairing mode by long press of the both buttons together. The display will turn into violet colour, and the Homebase will remain in pairing mode for 1 minute.
  2. Take the Thermosense thermometer and enclose it to the pairing magnet for 2 seconds. Pairing magnet you can find attached here on this page. Put it to the thermometer's area where QR code is stuck on its side. The thermometer will vibrate lengthy first and then will start vibrating fast.
  3. The thermometer is now searching for the Homebase. Devices will pair with each other. On the display of the Homebase, there will occur information about current temperature in tenths of °C (e.g. '245').
  4. Now, wait. The pairing sequence will end after 1 minute, and the Homebase will show actual temperature in final format (e.g. '24.5°C'). Homebase and Thermosense sensor will come into the general operating state. If the pairing process has failed, repeat it again from the point number 1. 
  5. Open the Energomonitor app in your browser and configure the new sensor.


Instructions for Thermosense Tripoint

  1. Choose one of the empty channels on your Homebase and switch the Homebase into pairing mode by long press of the both buttons together. The display will turn into violet colour, and the Homebase will remain in pairing mode for 1 minute.
  2. Take the Thermosense thermometer and enclose it to the pairing magnet for 2 seconds. Pairing magnet you can find attached here on this page. Put it to the thermometer's area where QR code is stuck on its side. The thermometer will vibrate lengthy first and then will start vibrating fast.
  3. The thermometer is now searching for the Homebase. Devices will pair with each other. On the display of the Homebase, there will occur information about current temperature in tenths of °C (e.g. '245').
  4. Now, wait. The pairing sequence will end after 1 minute, and the Homebase will show actual temperature in final format (e.g. '24.5°C'). Homebase and Thermosense sensor will come into the general operating state. If the pairing process has failed, repeat it again from the point number 1.
  5. Open the Energomonitor app in your browser and configure the new sensor.